UDOS – Monitor
Monitor #
- Hardware: Hardware specifications;
- Storage: storage status, storage remains;
- CPU: Utilization, temperature;
- Memory: Utilization, temperature;
- M.2 Drive: Utilization, temperature, read / write speed;
- Network: WiFi, Link speed, send / receive speed;
- Fans: Mode, Speed level, speed;
- Network: Ethernet and WiFi connection information;
- Processes: CPU, memory, read / write rate, processes;
- Sleep detection: Detect if drives can enter sleep mode;
Hardware #
- Viewing specifications of the hardware list;
Storage #
- Displaying storage status and storage remains by different users and folders;
CPU #
- Displaying the graphical statistics of CPU utilization and temperature changing via charts;
Memory #
- Displaying the graphical statistics of memory
M.2 Drive #
- Disk: Displaying the graphical statics of the Drive temperature and utilization changing;
- M.2 Drive: Displaying the Temperature, utilization, read / write speed of the SSDs;
Network #
- WiFi, Link speed, send / receive speed;
- Link Speed: Indicate the maximum transfer speed through WiFi;
- Send / receive speed: Indicate the real-time transfer speed;
- WiFi: Displays data receiving and sending;
Fans #
- Displaying the fan mode, speed level and fan’s speed(RPM);
Network Status #
- Ethernet: Network status, MAC address, IPv4 address, IPv4 subnet mask, IPv4 default gateway, IPv4 DNS, Public IPv4 address, IPv6 address;
- Wi-Fi: SSID, Signal strength, link speed, frequency, MAC address, IPv4 address, IPv4 subnet mask, IPv4 default gateway, IPv4 DNS, Public IPv4 address, IPv6 address;
Action #
- Customize Ethernet Settings and Wi-Fi Settings
Ethernet settings #
- Obtain IP address automatically: Only configure DNS;
- Use following IP address: Configure all specifications;
Wi-Fi settings #
- Enable Wi-Fi: Switch to enable/ disable WiFi;
- Wi-Fi reconnect: Reconnect to reset the connection;
- Configure Wi-Fi: Configure WiFi through bluetooth;
Processes #
- List and sort processes based on CPU, Memory, Read speed or write speed
Sleep detection #
- This is a detection that can check what processes are stopping hard drives from entering sleep mode.
- Results would look like following:
Updated on December 13, 2024